Devices “PIR-3M”, “PIR-4M” are intended for measurements of wall variations and wall thickness of cylindrical hollow parts (pipes). Devices are recommended for measurements of parameters of long- length- parts with spaces, hardly accessible or unavailable to introduction of measuring means. […]
The device is intended for measuring deviations of the inner diameter of pipes from reference values. Devices have gained a certification. Pattern Approval Certificate RU.C.27.005.A No.50107. Basic technical specifications Nominal diameter, mm 32…….100 Measuring range, mm d –0.2 […]
The device K-104 is intended for measurement of internal diameters of cylinders and the total depth of diametrically located flutes of variable sections. Basic technical characteristics Nominal diameter D to be measured, mm from 104 to 104.5 Nominal diameter D1 […]
It is intended for measurement of deviations of diameter of parts (pipes) from nominal rate on rifling lands and grooves. It is delivered for diameters 100, 120, 122, 152, 155 mm. Basic technical characteristics nominal diameter of a controlled […]
It is intended for measurement of a deviation of the internal diameter of pipes (cylinders) from nominal rates. Measurements are performed simultaneously in the horizontal and vertical planes. Fig. 2.1 – Overall view of the device “Kaskad-125” Basic technical characteristics […]
It is intended for measurement of deviations of axis of an internal cylindrical surface of a pipe (straightness). It is used at acceptance tests and for measurements when carrying out of technological operations (straightening of pipes). The device provides measurements […]
This measuring assembly (photo 1) is intended for measurement of a nonstraightness of cylinders of diverse diameters from 32 to 200 mm. At the assembly a measurement of a running nonstraightness is performed, on the basis of which a complete […]
It is intended for measurement of nonstraightness of cylinder axes over the basic length of 1 m in the horizontal plane. Basic set: measuring unit; recording unit (PC with the software); bar with a cable; calibration pipes. The device can […]
It is intended for measurement of deviations of internal diameter of cylinders from nominal rate. Basic set: measuring unit for one standard size; bar with a cable; adjusting rings of one standard size; accessory for setup and periodic calibration; PC […]