Назначение Приборы предназначены для измерения отклонения диаметра внутренней цилиндрической поверхности труб от номинального значения.Измерения производятся одновременно в горизонтальной и вертикальной плоскостях.
Products
Измерительный прибор «КАСКАД-ВЗД»
Назначение Прибор для измерения величины внутреннего диаметра статора по вершинам зубьев. Диапазон измерений внутренних диаметров статоров ВЗД от 36 до 150 мм обеспечивается базовыми измерительными головками со сменными направляющими. Погрешность измерения прибором в рабочем диапазоне по резине 0,05 мм. Информация […]
Device “Centre-6”, “Centre-6K”
The device is intended for measuring of non- uniform thickness (wall variations) of parts (pipes) and technological alignment of tubular billets on turning lathes in order to reach minimum non-uniform thickness (thickness variations) when lathe turning, for turning of collars […]
Devices “PIR-3M”, “PIR-4M”
Devices “PIR-3M”, “PIR-4M” are intended for measurements of wall variations and wall thickness of cylindrical hollow parts (pipes). Devices are recommended for measurements of parameters of long- length- parts with spaces, hardly accessible or unavailable to introduction of measuring means. […]
Device “Vizit-1M”
It is intended for measurement of deviations of axis of an internal cylindrical surface of a pipe (straightness). It is used at acceptance tests and for measurements when carrying out of technological operations (straightening of pipes). The device provides measurements […]
Assembly for measuring of nonstraightness of cylinder passages
This measuring assembly (photo 1) is intended for measurement of a nonstraightness of cylinders of diverse diameters from 32 to 200 mm. At the assembly a measurement of a running nonstraightness is performed, on the basis of which a complete […]
Measuring device “Struna”
It is intended for measurement of nonstraightness of cylinder axes over the basic length of 1 m in the horizontal plane. Basic set: measuring unit; recording unit (PC with the software); bar with a cable; calibration pipes. The device can […]
Measuring device “Kaskad”
It is intended for measurement of deviations of internal diameter of cylinders from nominal rate. Basic set: measuring unit for one standard size; bar with a cable; adjusting rings of one standard size; accessory for setup and periodic calibration; PC […]